Tel:
027-83373960 027-83373961
027-83373962 027-83373963
Fax:027-83373966
Email:info@boerchina.com
Address:NO.188 Gaoqiao Zrd Road,Wujiashan Econmic Development Zone,Wuhan.
Time: 2014/5/30 16:22:45 Author: Admin Hits:
(1): The machine tool, cutting fluid tank, pump and pipe should be cleaned before changing Fluid
(2): It’s better to prepare Cutting Fluid with the density from 0.5% to 1% and then cycle it for half an hour if the system is too dirty.
2: Mixing of Water Soluble Coolants
(1): Select the appropriate concentration of cutting fluid according to the processing.
(2): Fill the clean cutting fluid tank with enough water.
(3): Calculate the required amount of concentrated liquid.
(4): Stir the concentrated liquid slowly and add it into cutting fluid box.
(5): Cycle it more than 30 minutes.
3: The Daily Maintenance of Water Soluble Coolants.
(1): Avoid prolonged downtime, if it happened, cycle it 1 to 2 hours a day
(2): Clean extraneous oil in time
(3): Prevent the dirt from outside contamination.
(4): Maintain appropriate concentration
(5): Test the PH value regularly , monitor the working life of cutting fluid according to it.
4: Boer Detection Projects
* On-site Testing * Lab Analysis
* Appearance * Concentration
* Flavour * PH value
* Concentration * Bacterial Content
* PH value * Oil Spill
* Floating Soap
5: Customer On-site Testing
(1): Concentration:Using the refractometer.
(2): PH value: Using PH test paper or sophisticated PH meter.
6: Methods of Testing the Concentration of Cutting Fluid.
(1): Using the refract meter.
(2): Concentration =Measured Value of Refract meter * Refractive Index(different products has different refractive index).
Prev: Selection of Metalworking Fluids
Next: Waste Processing